Filter
Top Products
4-11
Configuration Guide for Cisco Secure ACS 4.2
OL-14390-02
Chapter 4 Using RDBMS Synchronization to Create dACLs and Specify Network Configuration
Using RDBMS Synchronization to Configure dACLs
Step 5 If the dACL was not created correctly, review the steps in Using RDBMS Synchronization to Configure
dACLs, page 4-2 and check for errors.
For a list of error messages, see Error Messages, page 4-11.
Error Messages
Table 4-3 lists the error messages associated with dACL creation using CSDBSync.
.
Ta b l e 4-3 dACL Creation Errors
Error Message Explanation
Failed to process DACL. DACL not defined.
Possible Cause The dACL was not specified
correctly in the text file used to define the
dACLs.
Recommended Action Review the text file that
you coded to specify the dACLs and ensure
that the syntax is correct.
Failed to process DACL. Could not find NAF.
Possible Cause The text file provided to
define the dACL did not correctly define a
NAF.
Recommended Action Review the text file that
you coded to specify the dACLs and ensure
that the syntax is correct.
Failed to process DACL. Failed to get UserID.
Possible Cause On the ACS SE, the user ID
specified for the FTP server in the RDBMS
Synchronization configuration was incorrect.
Recommended Action Check to ensure that the
specified user ID exists on the FTP server
used with the ACS SE.
Failed to process DACL. DACL content not
found.
Possible Cause The text file used to specify
the dACL did not correctly specify the dACL
content.
Recommended Action Check the syntax in the
text file and ensure that it is correct. Ensure
that the ACLs defined in the file are correct.
Failed to upload file into FTP server.
Possible Cause The FTP server was not
reachable, or a network error occurred.
Recommended Action Ensure that the IP
address for the FTP server in the RDBMS
configuration is correct and that the network
is functioning correctly.