Filter
Top Products
9-67
Configuration Guide for Cisco Secure ACS 4.2
OL-14390-02
Chapter 9 NAC Configuration Scenario
Step 8: Set Up Templates to Create NAPs
Profile Setup
To use the Profile Setup settings from the template:
Step 1 Go to Network Access Profiles.
Step 2 Choose the profile that you created.
Step 3 The Profile Setup page appears, as shown in Figure 9-51.
Figure 9-51 Profile Setup Page for Agentless Host for Layer 3 Template
The default settings for the profile are:
• Any appears in the Network Access Filter field, which means that this profile has no IP filter.
You can choose NAFs from the drop-down list, so that only specific host IPs match this profile.
• In the Protocol types list, Allow any Protocol type appears in the Protocol types list, which means
that no protocol type filter exists for this profile.