Filter
Top Products
5-9
Configuration Guide for Cisco Secure ACS 4.2
OL-14390-02
Chapter 5 Password Policy Configuration Scenario
Step 4: Configure Access Policy
Step 4: Configure Access Policy
This section describes how to configure administrative access policy.
Before You Begin
If you want to enable the SSL for administrator access, you must have completed the steps in Install the
CA Certificate, page 7-4, and Add a Trusted Certificate, page 7-4. After you have enabled SSL, ACS
begins using the SSL at the next administrator login. This change does not affect current administrator
sessions. In the absence of a certificate, ACS displays an error message when you attempt to configure
SSL.
To set up an ACS access policy:
Step 1 In the navigation bar, click Administration Control.
ACS displays the Administration Control page.
Step 2 Click Access Policy.
The Access Policy Setup page appears, as shown in Figure 5-4.