Filter
Top Products
4-23
Cisco MGX 8850 Multiservice Switch Installation and Configuration
Release 1.1.31, Part Number 78-11223-03 Rev. B0, May 2005
Chapter 4 Enclosure and Card Installation
Routing Data Cables
Note Fiber optic cabling and copper cabling take different paths on the cable manager. Use the cable
channels for the copper cabling, but run the fiber optic cables over the sheet metal portion.
Figure 4-20 Cable Management Assembly at the Back Enclosure
Routing Data Cables
Copper-based data cables from the back cards run up or down to the cable manager and pass through the
channels then run to either the left or right side of the rack. Fiber optic cables pass over the sheet metal
portion. The cables subsequently go to the related equipment (for example, CPE). The view in
Figure 4-21 shows only the cable manager on top.
17678
Upper cable
manager
Lower cable
manager