Filter
Top Products
CHAPTER
5-1
Cisco CRS-1 Carrier Routing System 8-Slot Line Card Chassis Installation Guide
OL-6256-08
5
Installing and Removing Exterior Components
This chapter provides instructions for installing and removing the exterior cosmetic components on the
Cisco CRS-1 Carrier Routing System 8-Slot Line Card Chassis. This chapter presents the following
topics:
• Overview of the Exterior Components
• Installing or Removing the Front Side Exterior Components
• Installing or Removing the Rear Side Exterior Components
Overview of the Exterior Components
Exterior cosmetic components for the Cisco CRS-1 8-slot line card chassis are not required to be
installed; they are provided as optional components (except for the cable management bracket, which is
preinstalled). The 8-slot line card chassis is shipped with the following exterior components:
• Cable management bracket (shipped preinstalled on the chassis)
• Inlet grille (shipped separately)
You can also install the optional exterior exhaust grille for the rear of the chassis. This exterior
component for the rear of the chassis does not ship automatically with the product; it must be ordered
separately.
Installing or Removing the Front Side Exterior Components
This section contains the following procedures:
• Removing the Cable Management Bracket
• Reinstalling the Cable Management Bracket
• Installing the Inlet Grille
• Removing the Inlet Grille