Filter
Top Products
4-36
Cisco CRS-1 Carrier Routing System 8-Slot Line Card Chassis Installation Guide
OL-6256-08
Chapter 4 Installing and Removing MSCs, PLIMs, and Associated Components
How to Install or Remove an MSC
Caution Use the cable management bracket to slide cards from the card carrier. Do not lift cards by the cable
management bracket! Rotate cards onto their vertical axes, then lift them from the bottom, using the
cable management bracket only as an aid for balance.
Required Tools and Equipment
You need the following tools and part to perform this task:
• ESD-preventive strap
• Medium flat-blade or Phillips screwdriver
• Impedance carrier (Cisco Product number CRS-MSC-IMPEDENCE=)
Steps
To remove an MSC, see Figure 4-26 and follow these steps:
Figure 4-26 Removing an MSC
1 Captive screw 3 Direction of installation or removal
2 Ejector lever
3
122922
1
2