Filter
Top Products
4-3
Cisco CRS-1 Carrier Routing System 8-Slot Line Card Chassis Installation Guide
OL-6256-08
Chapter 4 Installing and Removing MSCs, PLIMs, and Associated Components
Information About Installing and Removing Cards and Associated Components
Figure 4-2 shows how to operate the ejector levers. Be sure to operate both levers simultaneously.
Figure 4-2 Operating Ejector Levers
When shipped, every slot in the chassis contains either an impedance carrier, or is covered by a slot cover
(see the
“Information About Impedance Carriers and Slot Covers” section on page 4-6).
Note While it is not critical for you to install the cards in a certain order, following the card installation
recommendations in this chapter will make your installation process easier.
101406