Filter
Top Products
5-8
Cisco CRS-1 Carrier Routing System 8-Slot Line Card Chassis Installation Guide
OL-6256-08
Chapter 5 Installing and Removing Exterior Components
Installing or Removing the Rear Side Exterior Components
What to Do Next
Be sure that all parts have been carefully set aside and repackaged appropriately. If you have ordered the
optional cosmetic kit for the rear of the 8-slot chassis, proceed to the next section for instructions on
installing those components.
Installing or Removing the Rear Side Exterior Components
This section describes how to install or remove the optional exterior components for the rear of the Cisco
CRS-1 8-slot line card chassis. This section contains the following sections:
• Installing the Exhaust Grille
• Removing the Exhaust Grille
Installing the Exhaust Grille
This section describes how to install the exhaust grille. The grille covers the power module and air intake
areas at the bottom of the rear side of the chassis, just below the card cage (see
Figure 5-5).
Figure 5-5 Exhaust Grille
Prerequisites
No prerequisites exist for this task.
158083