Filter
Top Products
4-15
Cisco CRS-1 Carrier Routing System 8-Slot Line Card Chassis Installation Guide
OL-6256-08
Chapter 4 Installing and Removing MSCs, PLIMs, and Associated Components
How to Install or Remove a Slot Cover
Step 3 Partially tighten the four captive screws on the front panel of the slot cover (either by hand or with the
screwdriver) to make sure that they are both engaged.
Step 4 To seat the slot cover firmly in place, fully tighten the captive screws.
What to Do Next
After performing this task, replace any rear (MSC) side cosmetic covers.
Removing a Slot Cover
This section describes how to remove a slot cover from the Cisco CRS-1 8-slot line card chassis. The
chassis is shipped with slot covers over the switch fabric card and RP card slots. Both slot cover types
are removed in the same manner. (
Figure 4-13 shows a switch fabric slot cover for reference.) For more
detailed information on the slot covers, see the “Information About Impedance Carriers and Slot Covers”
section on page 4-6.
Figure 4-13 Switch Fabric Slot (Half Height) Slot Cover
122142