Filter
Top Products
4-23
Cisco CRS-1 Carrier Routing System 8-Slot Line Card Chassis Installation Guide
OL-6256-08
Chapter 4 Installing and Removing MSCs, PLIMs, and Associated Components
How to Install or Remove a Switch Fabric Card
Figure 4-17 Removing a Pillow Block
Step 3 Remove the lower left screw (located below the pillow block pin). (See item number 3 in Figure 4-17.)
Step 4 Remove the top left screw (located above the pillow block pin). (See item number 4 in Figure 4-17.)
Step 5 Remove the pillow block and set it aside.
Step 6 Repeat this procedure for the card slot’s other pillow block if necessary.
What’s Next
After performing this task, you may install a new pillow block (see the “Installing a Pillow Block”
section on page 4-20).
How to Install or Remove a Switch Fabric Card
This section contains the following procedures:
• Installing a Switch Fabric Card
• Removing a Switch Fabric Card
• Verifying the Installation of a Switch Fabric Card
Installing a Switch Fabric Card
This section describes how to install a switch fabric card in the Cisco CRS-1 8-slot line card chassis. For
more detailed information on the switch fabric card, see Cisco CRS-1 Series Carrier Routing System 8-Slot
Line Card Chassis System Description.
211480
4
2
1
3