Filter
Top Products
4-39
Cisco CRS-1 Carrier Routing System 8-Slot Line Card Chassis Installation Guide
OL-6256-08
Chapter 4 Installing and Removing MSCs, PLIMs, and Associated Components
How to Install or Remove an RP Card or DRP PLIM
Note For enhanced immunity to external electromagnetic disturbance levels of 10V per meter and 10 V RMS,
you must use a shielded Ethernet (CAT5 or better STP) cable on the Management Ethernet connection
of the RP card (CRS-8-RP).
Figure 4-28 Route Processor (RP) Card for the 8-Slot Chassis
Primary
Status
Console
AUX
CRITICAL
MAJOR
MINOR
149693
Optical Gigabit Ethernet for control
plane: (not user configurable)
Terminal connection
Modem connection
Primary RP (on=primary)
Card status (
g
reen=OK)
User-removable flash disk1
stores installation PIE files
A second internal flash disk0
stores installed software and
active configurations
Management Ethernet connection
for out-of-band network communication
LED status
displays
(alphanumeric)
ALARM
PID/VID
MGMT
ETH
CNTL
ETH 0
PC
CARD
CNTL
ETH 1
EXT
CLK 1
EXT
CLK 2
Remote terminal for
CLI communication
RJ-45 cable
Local terminal or
terminal server for
CLI communication
RJ-45 cable
Remote CLI, CWI, XML,
or SNMP communication.
Remote file storage
Ethernet cable
Network