Cisco Systems CRS-1 Network Router User Manual


 
ix
Cisco CRS-1 Carrier Routing System 8-Slot Line Card Chassis Installation Guide
OL-6256-08
Preface
Note Means reader take note. Notes contain helpful suggestions or references to materials not contained in
this manual.
Timesaver Means the described action saves time. You can save time by performing the action described in the
paragraph.
Warning
This warning symbol means
danger
. You are in a situation that could cause bodily injury. Before you
work on any equipment, be aware of the hazards involved with electrical circuitry and be familiar
with standard practices for preventing accidents. To see translations of the warnings that appear in
this publication, refer to the
Regulatory Compliance and Safety Information
document that
accompanied this device.
Statement 1074
Related Documentation
For complete information on the CRS-1 8-Slot Line Card Chassis, see the following publications:
Cisco CRS-1 Carrier Routing System 8-Slot Line Card Chassis Hardware Documentation Guide
Cisco CRS-1 Series Carrier Routing System 8-Slot Line Card Chassis Site Planning Guide
Cisco CRS-1 Carrier Routing System 8-Slot Line Card Chassis System Description
Cisco CRS-1 Carrier Routing System 8-Slot Line Card Chassis Unpacking, Moving, and Securing
Guide
Cisco CRS-1 Series Carrier Routing System 8-Slot Line Card Chassis Installation Guide
Cisco CRS-1 Carrier Routing System Regulatory Compliance and Safety Information
For a complete listing of available software documentation for the Cisco CRS-1 Carrier Routing System,
see the About Cisco IOS XR Software Documentation, available online at:
http://www.cisco.com/en/US/products/ps5845/index.html
Then check the links under “Technical Documentation & Tools.”
Changes to This Document
Table 1 lists the technical changes made to this document since it was first printed.
Table 1 Changes to This Document
Revision Date Change Summary
OL-6256-08 May 2008 New procedures on installing and removing a pillow block
were added to
Chapter 4, “Installing and Removing
MSCs, PLIMs, and Associated Components.”
OL-6256-07 February 2008 Minor technical changes.