Filter
Top Products
PERC 3/DC or PERC 3/DCL Hardware Installation 121
7 Connect SCSI devices.
8 Power on the host system.
9 Run the BIOS Configuration Utility or the WebBIOS Configuration
Utility.
10 Install the operating system software driver.
Step 1—Unpack the PERC 3/DC or PERC 3/DCL
Unpack and install the hardware in a static-free environment. Remove the
controller card and inspect it for damage. If the card appears damaged,
please contact your Dell support representative.
Step 2—Power Down
Turn off the computer and remove the AC power cord. Ensure that the
computer is disconnected from any networks before installing the controller.
Remove the system cover. For information regarding removal of system
covers, please consult the system documentation.
Step 3—Set Jumpers
Make sure the jumper settings on the PERC 3/DC or PERC 3/DCL card are
correct. The jumpers and connectors are shown in Table 9-1.
Table 9-1. Jumper Settings
Connector Description Type
J2 Channel 1 termination enable 3-pin header
J3 Channel 0 termination enable 3-pin header
J4 Channel 0 internal Wide SCSI 68-pin connector
J5 Channel 1 internal Wide SCSI 68-pin connector
J7 Channel 0 external Wide SCSI 68-pin connector
J8 Serial erasable programmable read-
only memory (EEPROM) port
2-pin header
J9 Onboard BIOS enable 2-pin header
J10 Non-volatile random access memory
(NVRAM) clear
2-pin connector
J11 Serial port connector 3-pin header