Filter
Top Products
To configure a management interface, use the following commands.
• Enter the slot and the port (1) to configure a Management interface.
CONFIGURATION mode
interface managementethernet interface
The slot range is 1.
The port range is from 1 to 6.
• Configure an IP address and mask on a Management interface.
INTERFACE mode
ip address ip-address mask
– ip-address mask: enter an address in dotted-decimal format (A.B.C.D). The mask must be in /
prefix format (/x).
Configuring Management Interfaces on the S-Series
You can manage the S-Series from any port.
To configure an IP address for the port, use the following commands. There is no separate management
routing table, so configure all routes in the IP routing table (the ip route command).
• Configure an IP address.
INTERFACE mode
ip address
• Enable the interface.
INTERFACE mode
no shutdown
• The interface is the management interface.
INTEFACE mode
description
Example of the show interface and show ip route Commands
To display the configuration for a given port, use the show interface command in EXEC Privilege
mode, as shown in the following example. To display the routing table, use the show ip route
command in EXEC Privilege mode.
Dell#show int TenGigabitEthernet 1/1/1
TenGigabitEthernet 1/1/1 is up, line protocol is up
Description: This is the Managment Interface
Hardware is Force10Eth, address is 00:01:e8:cc:cc:ce
Current address is 00:01:e8:cc:cc:ce
Pluggable media not present
Interface index is 46449666
Internet address is 10.11.131.240/23
[output omitted]
Dell#show ip route
Codes: C - connected, S - static, R - RIP,
B - BGP, IN - internal BGP, EX - external BGP,LO - Locally Originated,
396
Interfaces