Filter
Top Products
128.3
Te 1/10 128.230 128 2000 FWD 0 0 90b1.1cf4.9b79
128.230
Te 1/13 128.233 128 2000 FWD 0 0 90b1.1cf4.9b79
128.233
Interface
Name Role PortID Prio Cost Sts Cost Link-type Edge
---------- ------ -------- ---- ------- ----------- ------- --------- ----
Po 1 Desg 128.2 128 188 FWD 0
(vltI)P2P No
Po 2 Desg 128.3 128 2000 FWD 0 (vlt) P2P No
Te 1/10/1 Desg 128.230 128 2000 FWD 0 P2P Yes
Te 1/10/3 Desg 128.233 128 2000 FWD 0 P2P No
Dell#
eVLT Configuration Example
The following example demonstrates the steps to configure enhanced VLT (eVLT) in a network.
In this example, you are configuring two domains. Domain 1 consists of Peer 1 and Peer 2; Domain 2
consists of Peer 3 and Peer 4, as shown in the following example.
In Domain 1, configure Peer 1 fist, then configure Peer 2. When that is complete, perform the same steps
for the peer nodes in Domain 2. The interface used in this example is TenGigabitEthernet.
Figure 121. eVLT Configuration Example
eVLT Configuration Step Examples
In Domain 1, configure the VLT domain and VLTi on Peer 1.
Domain_1_Peer1#configure
Domain_1_Peer1(conf)#interface port-channel 1
Domain_1_Peer1(conf-if-po-1)# channel-member TenGigabitEthernet 1/8-9/1
Domain_1_Peer1(conf)#vlt domain 1000
Domain_1_Peer1(conf-vlt-domain)# peer-link port-channel 1
Domain_1_Peer1(conf-vlt-domain)# back-up destination 10.16.130.11
Virtual Link Trunking (VLT)
973