Dell S6000-ON Switch User Manual


  Open as PDF
of 1100
 
===================================
SFP 4/1 Temp High Alarm threshold = 0.000C
SFP 4/1 Voltage High Alarm threshold = 0.000V
SFP 4/1 Bias High Alarm threshold = 0.000mA
Link Dampening
Interface state changes occur when interfaces are administratively brought up or down or if an interface
state changes.
Every time an interface changes a state or flaps, routing protocols are notified of the status of the routes
that are affected by the change in state. These protocols go through the momentous task of re-
converging. Flapping; therefore, puts the status of entire network at risk of transient loops and black
holes.
Link dampening minimizes the risk created by flapping by imposing a penalty for each interface flap and
decaying the penalty exponentially. After the penalty exceeds a certain threshold, the interface is put in an
Error-Disabled state and for all practical purposes of routing, the interface is deemed to be “down.” After
the interface becomes stable and the penalty decays below a certain threshold, the interface comes up
again and the routing protocols re-converge.
Link dampening:
reduces processing on the CPUs by reducing excessive interface flapping.
improves network stability by penalizing misbehaving interfaces and redirecting traffic.
improves convergence times and stability throughout the network by isolating failures so that
disturbances are not propagated.
Important Points to Remember
Link dampening is not supported on VLAN interfaces.
Link dampening is disabled when the interface is configured for port monitoring.
You can apply link dampening to Layer 2 and Layer 3 interfaces.
You can configure link dampening on individual interfaces in a LAG.
Enabling Link Dampening
To enable link dampening, use the following command.
Enable link dampening.
INTERFACE mode
dampening
Examples of the show interfaces dampening Commands
To view the link dampening configuration on an interface, use the show config command.
R1(conf-if-te-1/1/1)#show config
!
interface TenGigabitEthernet 1/1/1
ip address 10.10.19.1/24
dampening 1 2 3 4
no shutdown
416
Interfaces