Filter
Top Products
xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch
85
Acceptable
Frame Type
This field denotes the type of frame that will be accepted by the port. The user may choose
between Tagged Only, which means only VLAN tagged frames will be accepted, and Admit_All,
which mean both tagged and untagged frames will be accepted. Admit_All is enabled by default.
Click Apply to implement changes made.
Double VLAN
Click L2 Features > VLAN > Double VLAN Settings, which will display the following window to enable the Double VLAN
feature.
Figure 7- 10. Double VLAN State Settings
Choose Enable using the pull-down menu and click Apply. The user will be prompted with the following warning window. Click
OK to continue. When OK is clicked, all switch settings except the IP will return to their default values.
After being prompted with a success message, the user will be presented with this window to configure for Double VLANs.
Figure 7- 11. Double VLAN Table
Parameters shown in the previous window are explained below:
Parameter Description
Double VLAN
State
Use the pull-down menu to enable or disable the Double VLAN function on this Switch. Enabling
the Double VLAN will return all previous VLAN configurations to the factory default settings and
remove Static VLAN configurations from the GUI.
SPVID
The VLAN ID number of this potential Service Provider VLAN.
VLAN Name
The name of the VLAN on the Switch.
TPID
The tagged protocol ID of the corresponding VLAN that will be used in identification of this
potential Double VLAN, written in hex form.
Uplink Ports
Uplink ports are for connecting Switch VLANs to the Provider VLANs on a remote source. Only