Filter
Top Products
xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch
203
Figure 10- 2. Access Profile Table (Ethernet)
The following parameters can be set, for the Ethernet type:
Parameter Description
Profile ID (1-255)
Type in a unique identifier number for this profile set. This value can be set from 1 – 255, yet
only 9 access profiles can be created on the Switch.
Type
Select profile based on Ethernet (MAC Address), IP address, or packet content mask. This
will change the menu according to the requirements for the type of profile.
• Select Ethernet to instruct the Switch to examine the layer 2 part of each packet
header.
• Select IP to instruct the Switch to examine the IP address in each frame's header.
• Select Packet Content Mask to specify a mask to hide the content of the packet
header.
• Select IPv6 to instruct the Switch to examine the IPv6 address in each frame's
header.
VLAN
Selecting this option instructs the Switch to examine the VLAN identifier of each packet
header and use this as the full or partial criterion for forwarding.
Source MAC
Source MAC Mask - Enter a MAC address mask for the source MAC address.
Destination MAC
Destination MAC Mask - Enter a MAC address mask for the destination MAC address.
802.1p
Selecting this option instructs the Switch to examine the 802.1p priority value of each packet
header and use this as the, or part of the criterion for forwarding.
Ethernet type
Selecting this option instructs the Switch to examine the Ethernet type value in each frame's
header.
NOTE: IP-MAC Binding ACL entries can only be removed form the Access
Profile table by using the IP-MAC Binding window, mentioned earlier in
this manual. The Clear All button will only remove entries created in the
Access Profile window.