D-Link DES-3800 Series Switch User Manual


 
xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch
2
has two combo 1000 Base-T/SFP ports on the front panel and two 1000 Base-T ports on the back. These gigabit combo ports are
ideal for connecting to a server or network backbone. See the “Ports” section below for differences between the front and rear
Gigabit combo ports.
This Switch enables the network to use some of the most demanding multimedia and imaging applications concurrently with other
user applications without creating bottlenecks. The built-in console interface can be used to configure the Switch's settings for
priority queuing, VLANs, and port trunk groups, port monitoring, and port speed.
Features
IEEE 802.3ad Link Aggregation Control Protocol support.
IEEE 802.1x Port-based and MAC-based Access Control
IEEE 802.1Q VLAN
IEEE 802.1D Spanning Tree, IEEE 802.1W Rapid Spanning Tree and IEEE 802.1s Multiple Spanning Tree support
Access Control List (ACL) support
Single IP Management support
Access Authentication Control utilizing TACACS, XTACACS and TACACS+
Dual Image Firmware
Simple Network Time Protocol support
MAC Notification support
System and Port Utilization support
System Log Support
Support port-based enable and disable
Address table: Supports up to 16K MAC addresses per device
Supports a packet buffer of up to 32M bytes
Supports Port-based VLAN Groups
Port Trunking with flexible load distribution and fail-over function
IGMP Snooping support
SNMP support
Secure Sockets Layer (SSL) and Secure Shell (SSH) support
Port Mirroring support
WRED support
Web-based Access Control
MAC-Based Access Control
MIB support for:
RFC1213 MIB II
RFC1493 Bridge
RFC2819 RMON
RFC2665 Ether-like MIB
RFC2863 Interface MIB
Private MIB
RFC4363 for P,Q BRIDGE
IEEE 802.1x MIB
RFC1724 RIPv2
RFC1850 OSPF
RFC1907 SNMPv2
RFC2021 RMON2
RFC2906 IP-FORWARD
RFC2571 SNMP-FRAMEWORK
RFC2572 SNMP-MPD
RFC2573 SNMP-TARGET
RFC2574 SNMP-USER-BASED-SM
RFC2575 SNMP-VIEW-BASED-ACM