Filter
Top Products
xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch
289
To configure a port or range of ports for the MAC-Based Access Control feature, use the From and To pull-down menus to
choose the ports, and then use the State pull-down menu to enable them. To view the MAC address authentication on a port-by-
port basis, click the hyperlinked port number, which will display the following window listing that pertinent information, as seen
below.
Figure 11- 64. MAC-Based Authentication port 1 Status Table
MAC-Based Access Control Local Database Settings
The following window is used to set a list of MAC addresses, along with their corresponding target VLAN, which will be
authenticated for the Switch. Once a queried MAC address is matched in this table, it will be placed in the VLAN associated with
it here. The switch administrator may enter up to 1024 MAC addresses to be authenticated using the local method configured here.
To view this window, click Security > MAC-Based Access Control > MAC-Based Access Control Local Database Settings.
Figure 11- 65. MAC-Based Access Control Local Database Settings
To add a MAC address to the local authentication list, enter the MAC address and the target VLAN name into their appropriate
fields and click Add. To change a MAC address or a VLAN in the list, enter its parameters into the appropriate fields and click
Modify. To delete a MAC address entry, enter its parameters into the appropriate fields and click Delete, or click the
corresponding
of the entry in the MAC-Based Access Control Local Database Table.