Filter
Top Products
xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch
172
VRRP
VRRP or Virtual Routing Redundancy Protocol is a function on the Switch that dynamically assigns responsibility for a virtual
router to one of the VRRP routers on a LAN. The VRRP router that controls the IP address associated with a virtual router is
called the Master, and will forward packets sent to this IP address. This will allow any Virtual Router IP address on the LAN to be
used as the default first hop router by end hosts. Utilizing VRRP, the administrator can achieve a higher available default path cost
without needing to configure every end host for dynamic routing or routing discovery protocols.
Statically configured default routes on the LAN are prone to a single point of failure. VRRP is designed to eliminate these failures
by setting an election protocol that will assign a responsibility for a virtual router to one of the VRRP routers on the LAN. When a
virtual router fails, the election protocol will select a virtual router with the highest priority to be the Master router on the LAN.
This retains the link and the connection is kept alive, regardless of the point of failure.
To configure VRRP for virtual routers on the Switch, an IP interface must be present on the system and it must be a part of a
VLAN. VRRP IP interfaces may be assigned to every VLAN, and therefore IP interface, on the Switch. VRRP routers within the
same VRRP group must be consistent in configuration settings for this protocol to function optimally.
VRRP Global Settings
To enable VRRP globally on the Switch, click L3 Features > VRRP > VRRP Global Settings:
Figure 8- 56. VRRP Global Settings window
The following fields can be set:
Parameter Description
VRRP State
Use the pull-down menu to enable or disable VRRP globally on the Switch. The
default is Disabled.
Non-Owner Response Ping
Enabling this parameter will allow the virtual IP address to be pinged from other host
end nodes to verify connectivity. This will only enable the ping connectivity check
function. This command is Disabled by default.
Click Apply to implement changes made.
VRRP Virtual Router Settings
The following window will allow the user to view the parameters for the VRRP function on the Switch. To view this window,
click L3 Features > VRRP > VRRP Virtual Router Settings:
Figure 8- 57. VRRP Virtual Router Settings window
The following fields are displayed in the window above: