Filter
Top Products
xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch
227
Figure 10- 16. CPU Interface Filtering Rule Configuration – Ethernet
To set the CPU Access Rule for Ethernet, adjust the following parameters and click Apply.
Parameters Description
Profile ID
This is the identifier number for this profile set.
Mode
Select Permit to specify that the packets that match the access profile are forwarded by the
Switch, according to any additional rule added (see below).
Select Deny to specify that packets that match the access profile are not forwarded by the
Switch and will be filtered.
Access ID
Type in a unique identifier number for this access and priority. This value can be set from 1 -
65535.
Type
Selected profile based on Ethernet (MAC Address), IP address or Packet Content.
• Ethernet instructs the Switch to examine the layer 2 part of each packet header.
• IP instructs the Switch to examine the IP address in each frame's header.
• Packet Content Mask instructs the Switch to examine the packet header.
VLAN Name
Allows the entry of a name for a previously configured VLAN.
Source MAC
Source MAC Address - Enter a MAC Address for the source MAC address.
Destination MAC
Destination MAC Address - Enter a MAC Address mask for the destination MAC address.
802.1P (0-7)
Enter a value from 0-7 to specify that the access profile will apply only to packets with this
802.1p priority value.
Ethernet Type
Specifies that the access profile will apply only to packets with this hexadecimal 802.1Q
Ethernet type value (hex 0x0-0xffff) in the packet header. The Ethernet type value may be
set in the form: hex 0x0-0xffff, which means the user may choose any combination of letters
and numbers ranging from a-f and from 0-9999.
To view the settings of a previously configured rule, click in the Access Rule Table to view the following screen: