Filter
Top Products
xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch
169
DHCP/BOOTP Relay Interface Settings
The DHCP/ BOOTP Relay Interface Settings allow the user to set up a server, by IP address, for relaying DHCP/ BOOTP
information. The user may enter a previously configured IP interface on the Switch that will be connected directly to the
DHCP/BOOTP server using the following window. Properly configured settings will be displayed in the BOOTP Relay Table at
the bottom of the following window, once the user clicks the Add button under the Apply heading. The user may add up to four
server IPs per IP interface on the Switch. Entries may be deleted by clicking it’s corresponding
. To enable and configure
DHCP/BOOTP Relay Interface Settings on the Switch, click L3 Features > DHCP/BOOTP Relay > DHCP/BOOTP Relay
Interface Settings:
Figure 8- 53. DHCP/BOOTP Relay Interface Settings and DHCP/BOOTP Relay Interface Table window
NOTE: The secondary IP interface does not support DHCP/BOOTP relay. Only the
primary IP interface supports DHCP/BootP relay.
The following parameters may be configured or viewed.
Parameter Description
Interface
The IP interface on the Switch that will be connected directly to the Server.
Server IP
Enter the IP address of the DHCP/BOOTP server. Up to four server IPs can be configured per IP
Interface