Filter
Top Products
xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch
210
Figure 10-9. Access Rule Configuration window (IP)
Configure the following Access Rule Configuration settings:
Parameter Description
Profile ID
This is the identifier number for this profile set.
Mode
Select Permit to specify that the Switch, according to any additional rule, forward the
packets that match the access profile added (see below).
Select Deny to specify that packets that do not match the access profile are not forwarded
by the Switch and will be filtered.
Select Mirror to monitor the packets forwarded by the switch.
Access ID (1-65535)
Type in a unique identifier number for this access or use Auto Assign.
Type
Selected profile based on Ethernet (MAC Address), IP address, Packet Content Mask or
IPv6.
• Ethernet instructs the Switch to examine the layer 2 part of each packet header.
• IP instructs the Switch to examine the IP address in each frame's header.
• Packet Content Mask instructs the Switch to examine the packet header.
• IPv6 instructs the switch to examine the IPv6 address in each frame’s header.
Priority (0-7)
This parameter is specified if you want to re-write the 802.1p default priority previously set in
the Switch, which is used to determine the CoS queue to which packets are forwarded to.
Once this field is specified, packets accepted by the Switch that match this priority are
forwarded to the CoS queue specified previously by the user.
Replace Priority with − Click the corresponding box if you want to re-write the 802.1p default
priority of a packet to the value entered in the Priority (0-7) field, which meets the criteria
specified previously in this command, before forwarding it on to the specified CoS queue.
Otherwise, a packet will have its incoming 802.1p user priority re-written to its original value