Filter
Top Products
6 - 6
NGA 2000
90003749(1) [NGA-e (Software CLD 2.3/MLT 3.1.X)] 04/98
In the menu "Auxiliary lines" you can determine if the last four lines in the single
component display of the current channel shall appear. If you want to set up the lines of
the other channels of the joint analyzer modules, press the F3 key.
Set up parameters:
♦ Select any line of variables or any menu line with the ↓↓ -key or the ↑↑ -key.
♦ Select the parameter with the ENTER key or the →→ -key.
♦ Select "Enabled" or "Disabled" with the ↑↑ -key or the ↓↓ -key to enable or disable the
display of the corresponding auxiliary line in the single component display.
♦ Confirm the parameter selected with the ENTER key or cancel and go back to the last
adjustment with the F2 key.
Choose the source module for the auxiliary lines:
You will change via the line "First line source...", "Second line source...", "Third line
source..." or "Last line source..." to the corresponding submenus. The tags of all modules
combined with the platform or MLT analyzer are available:
♦ Go to the line you want with the ↑↑ -key or the ↓↓ -key.
If there are more than eight source modules available you have to press the F3 key to
go to another menu page.
♦ Select the tag of the module with the ENTER key or the →→ -key:
The display will go back to the menu "Auxiliary lines" automatically.
The selection will be done.
Menu line "Units...":
From the menu "Main display configuration" you can change via the line "Units..." to the
submenu "Units control":
HOME ESCAPE MORE BACK INFO
CLD
F1 F2 F3 F4 F5
95.0 ppm
First auxiliary line source
Select the module to use as source for this line
CLD
in the single analyzer display screen.