Filter
Top Products
90003749(1) [NGA-e (Software CLD 2.3/MLT 3.1.X)] 04/98
NGA 2000
5 - 51
Main Menu — Expert controls and set up
↓↓
System set up
↓↓
Auxiliary lines
↓↓
In the menu "Auxiliary lines" you can determine if the last four lines in the single
component display of the current channel shall appear. If you want to set up the lines of
the other channels of the joint analyzer modules, press the F3 key.
Set up parameters:
♦ Select any line of variables or any menu line with the ↓↓ -key or the ↑↑ -key.
♦ Select the parameter with the ENTER key or the →→ -key.
♦ Select "Enabled" or "Disabled" with the ↑↑ -key or the ↓↓ -key to enable or disable the
display of the corresponding auxiliary line in the single component display.
♦ Confirm the parameter selected with the ENTER key or cancel and go back to the last
adjustment with the F2 key.
Choose the source module for the auxiliary lines:
Press the ENTER key or the →→ -key in the line "First line source...", "Second line
source...", "Third line source..." or "Last line source..." to change to the corresponding
submenu. The tags of all modules combined with the platform or the MLT analyzer are
available:
HOME ESCAPE NEXT INFO
CLD
F1 F2 F3 F4 F5
95.0 ppm
Auxiliary lines
First auxiliary line: Enabled
Third auxiliary line: Enabled
Fourth auxiliary line: Enabled
First line source...
Second line source...
Last line source...
Second auxiliary line: Enabled
Third line source...
5.4.3 System Set Up
Auxiliary Lines