Filter
Top Products
90003749(1) [NGA-e (Software CLD 2.3/MLT 3.1.X)] 04/98
NGA 2000
6 - 21
Main Menu — Technical level configuration
↓↓
Service menus
↓↓
Service history
↓↓
Control module history
↓↓
In the menu "Control Module Service History" you will find the manufacturing date of the
control module and the date since the control module is in service. Besides, you can find
the last service date in the corresponding line. After service is done you can set up a new
service date with the function "Add service date!". The new date will appear in the line
"Last service date:" after you will have changed to the single component display.
Set up parameters:
♦ Select the line "In service date:", the line "List notes..." or the line "Add service date!"
with the ↓↓ -key or ↑↑ -key.
♦ Press the ENTER key or the →→ -key to select the variable, to start the function or to
change to the submenu.
♦ Select any digit with the ←← -key or the →→ -key and adjust a new value with
the ↑↑ -key or the ↓↓ -key.
♦ Confirm the new value with the ENTER key or cancel and go back to the last value with
the F2 key.
Menu line "List notes...":
Via the line "List notes..." you can change to the submenu "Control Unit Service notes"
where you can give in a short note about the service you have done:
HOME ESCAPE INFO
CLD
F1 F2 F3 F4 F5
95.0 ppm
Control Module Service History
Manufacturing date: 16.11.1997
Last service date: 08:39:55 09 Feb 1998
List notes...
Add service date!
In service date: 16.11.1997
6.2.3 Service Menus
Control Module History