Filter
Top Products
3 - 4
NGA 2000
90003749(1) [NGA-e (Software CLD 2.3/MLT 3.1.X)] 04/98
MENU
♦ Change from the single component display to the main menu or from several submenus
to higher menus.
ESCAPE or <<<
♦ Changing back to the last menu page selected.
♦ Reset of a changed but not confirmed parameter to the former value resp. to zero.
BACK
♦ Reset of a changed but not confirmed parameter to the former value.
LOCK
♦ Lock of any operation level, if activated. Each of the three operation levels has to be
activated separately.
♦ F4 key of the main menu.
NEXT
♦ Change of the channel in the same menu. This will only be possible, if several channels
of an analyzer or of combined analyzers are existing. Then, all available channels can
be selected one after another.
♦ In the main menu you can move among all channels of the connected analyzers and
analyzer modules. In the submenus you can only move among the channels of the
current analyzer or analyzer module.
INFO
♦ Change to menus containing status or help informations of the actual menu.
♦ If available, this function is always assigned to the F5 key.
3.6 Entering/Changing of Variables
ENTER Key
♦ If you will press this key in a line of variables, the parameter will be displayed white on
black and can be changed. After you will have set up a new value, you can confirm it by
pressing the ENTER key again.
↑↑ -key / ↓↓ -key
♦ Function will depend on the variable selected: - Changing of the parameter values
- Scrolling among variables selected
- Changing of digits or characters
♦ Numbers consisting of several digits will increase/decrease totally, not digit by digit.
←← -key / →→ -key
♦ Selection of digits within a parameter.
♦ For some variables you can change the quantity of digits or characters.