Filter
Top Products
90003749(1) [NGA-e (Software CLD 2.3/MLT 3.1.X)] 04/98
NGA 2000
5 - 23
Main Menu — Expert controls and set up
↓↓
Analyzer module set up
↓↓
Analyzer Parameter List
↓↓
In the menu "Analyzer Parameter List" you can set up parameters of the single component
display, of the ozonator and the analyzer tag. You can also change to several submenus,
where you can set up linearizer parameters, concentration and calibration parameters.
Set up parameters:
♦ Select any line of variables or the menu line "Linearizer parameters..." with
the ↓↓ -key or the ↑↑ -key.
♦ Select the variable or change to the submenu "Linearity coefficients" with
the ENTER key or the →→ -key.
♦ Select any digit with the ←← -key or the →→ -key and adjust a new value with
the ↑↑ -key or the ↓↓ -key
resp. select the whole parameter with the ↑↑ -key or the ↓↓ -key.
♦ Confirm the new value with the ENTER key or
cancel and go back to the last value with the F2 key.
Line of variables "Analyzer tag":
You can input a tag of maximum thirty digits. You will find the same line in the menu
"Analyzer module set up" (see chapter 5.1 p. 5-3).
Caution:
Normally, you will find "CLD" as analyzer module tag in the line "analyzer tag".
If the CLD module is part of an analyzer network: You have to change the configu-
ration of the programmable digital inputs and analog outputs, if you change the
identification tag ! Because, the parameters of the module source will change ! So,
the relations will disappear !
HOME ESCAPE NEXT LAST INFO
CLD
F1 F2 F3 F4 F5
95.0 ppm
Analyzer Parameter List
Analyzer tag: CLD
Ozonator status: OFF - PRESSURE
Ozonator power: Enabled
First line´s parameter: Sample press.:
Second line´s parameter: Detector temperature:
Third line´s parameter: Block temperature:
Linearizer parameters...
Fourth line´s parameter: Converter temp.:
5.1.9 Analyzer Module Set up
Analyzer Parameter List