Filter
Top Products
EPSON Stylus Photo 750 Revision A
Troubleshooting Repair of the Control Board 45
3.4 Repair of the Control Board
This section describes the problems related to the power supply board. The table below provides various symptoms, likely causes, and checkpoints.
The checkpoints refer to waveforms, resistance, and other values to check to evaluate the operation of each component.
Table 3-7. Repair of the Control Board Table 3-8. Repair of the Control Board
Sympto
m
Condition Cause Check point Solution
The
printer
does not
operate at
all.
CPU does
not work.
Reset
circuit is
broken.
Check +5VDC line(Pin 7 of IC8) and
reset signal (Pin 2 of IC8).
Replace
IC8.
ROM is not
selected
correctly.
Check that the waveform of Pin 11
of IC3 reverses High/Low.
Replace
T1.
RAM is
broken.
Replace
Q1.
CPU is
broken.
Check the signal waveform Pin 88
of IC1.