Filter
Top Products
R
ESTRICTED USE ONLY Fargo Electronics, Inc.
Persona C10/M10 ID Card Printer Service Manual (Rev. 4.0)
116
Replacing the Rear Pivot Cover (830168)
It may be necessary to remove the Rear Pivot Cover or the Front Cover for many of the
replacement procedures in this section.
Refer To Drawing 8301XX.
TTR: 5 minutes.
Step Procedure
1 Unplug the power cord from the printer.
2 Stand at the rear of the printer and remove the top two corner Screws
(130971); loosen the bottom two corner Screws (130971).
3 Raise the Rear Pivot Cover and open the Upper Imaging Assembly.
4 Remove the top two mid-section Screws (130971); see drawing 830168.
5 Close the Upper Imaging Assembly.
6 Loosen the Screw (130971) by the Card Hopper and the Screw (130971) by
the Card Exit Ramp; see drawing 830168.
7 Grasp the bottom lip of either side of the Rear Pivot Cover, spread the sides
carefully past the remaining loosened Screws (130971), and lift the cover
assembly from the printer.