Filter
Top Products
R
ESTRICTED USE ONLY Fargo Electronics, Inc.
Persona C10/M10 ID Card Printer Service Manual (Rev. 4.0)
126
Replacing the Left Card Sensor Assembly (830135)
Caution: This device is electrostatic sensitive. It may be damaged if exposed to
static electrical discharges. (Discharges may be generated by various means, such as
walking on a carpeted floor.) Be sure to observe all established Electro-Static Discharge
(ESD) procedures while handling cables in or near the Circuit Board and Printhead
Assemblies. Always wear an appropriate personal grounding device, such as a wrist strap
with integral resistor, connected to an ESD ground to avoid potential damage. At a minimum,
make positive contact with the bare metal chassis of the printer with the hand before
proceeding with the procedure.
Refer To Drawing 830117-XX.
TTR: 15 minutes.
Step Procedure
1 Unplug the power cord from the printer.
2 Remove the Rear Pivot Cover.
3 Detach the Print Circuit Board from the chassis without the removing wire
connectors.
4 Remove the Screw (130939) from the Left Card Sensor Assembly (830135).
5 Disconnect the cable connection from J8 on the Print Circuit Board.
6 Attach a string to the cable connector; carefully draw it through the wire path.
7
Take the Left Card Sensor Assembly from the printer. Note: Use the string as
a means of guiding the new Left Card Sensor Assembly cable through the
printer.