Filter
Top Products
R
ESTRICTED USE ONLY Fargo Electronics, Inc.
Persona C10/M10 ID Card Printer Service Manual (Rev. 4.0)
121
Replacing the Printhead Harness Assembly (830162-00)
Refer To Drawing 830119-XX.
TTR: 15 minutes.
Note: The Printhead Harness Assembly includes the following cables: Data and Power Bus
cables for the Printhead, Cooling Fan, Ribbon Sensor Board Assembly, and the Headlift
Sensor Switch.
Step Procedure
1 Unplug the power cord from the printer.
2 Raise the Rear Pivot Cover.
3 Lift the Head Latch Lever and raise the Upper Imaging Assembly.
4 Unscrew the two Thumb Screws (130887).
5 Remove the Head Cover Plate (820253).
6 Raise the tip of the Head Spring (810214) about ¼-inch above the Printhead
Assembly (820199).
7 Grasp the two plastic forks on each side of the Printhead Assembly, pivot them
upward, and release the Head Spring.
8 Disconnect the two cables from the printhead. Make a note as to how the cables
are oriented for installing the replacement Printhead.
9 Pivot the Printhead Assembly back to its normal position.
10 Take the two Screws (130990) from the Fan Guard (150312); lift the fan out of
the printer.
11 Remove the two Screws (130971) that secure the Shield Sensor (810303) to the
Sensor Mount Bracket (810221).
12 Take the Ribbon Sensor Assembly from the printer.