Filter
Top Products
R
ESTRICTED USE ONLY Fargo Electronics, Inc.
Persona C10/M10 ID Card Printer Service Manual (Rev. 4.0)
30
Loading Ribbon Into The Printer (continued)
Step Procedure
6 Place the take-up end of the Ribbon roll in between the two black Ribbon Drive
Hubs located on the left-hand side of the Printer’s interior.
7 Load the Ribbon take-up end of the Ribbon just as you loaded the Ribbon supply
end.
8 When loaded properly, the Ribbon should feed underneath both ends of the
Ribbon roll. Grasp the Release Tab and gently lower the Printhead Assembly to
close it.
9 Lift slightly on the Release Tab to latch the assembly shut. Close the Printer’s
Top Cover. When you start to print, the Ribbon Drive Hubs will automatically
engage the notches on both cores of the Ribbon roll.
Caution: Do not reverse the Ribbon. Damage may occur to the thermal Printhead!