Filter
Top Products
R
ESTRICTED USE ONLY Fargo Electronics, Inc.
Persona C10/M10 ID Card Printer Service Manual (Rev. 4.0)
44
Resolving problems with Ribbon winding and printing
Step Procedure
1 Gently insert the tip of a small flathead screw Driver into the hole so it fits into the
slot of RP2. Slightly rotate RP2 in either direction until both the on-line and
On/Cancel LED’s turn OFF.
Caution: RP2 cannot be rotated all the way around. It has a stopping
point in each direction. Do not rotate RP2 beyond these points.
2 Once both LED’s are OFF, Ribbon Sensor calibration is complete.
3 Remove the power cable, open the Top Cover and flip Switch 1 toward the front
of the Printer to turn the switch back OFF. Close the Top Cover, reconnect the
power cable and try the print job again.