Filter
Top Products
R
ESTRICTED USE ONLY Fargo Electronics, Inc.
Persona C10/M10 ID Card Printer Service Manual (Rev. 4.0)
127
Replacing the Headlift Motor Assembly (830143)
Caution: This device is electrostatic sensitive. It may be damaged if exposed to
static electrical discharges. (Discharges may be generated by various means, such as
walking on a carpeted floor.) Be sure to observe all established Electro-Static Discharge
(ESD) procedures while handling cables in or near the Circuit Board and Printhead
Assemblies. Always wear an appropriate personal grounding device, such as a wrist strap
with integral resistor, connected to an ESD ground to avoid potential damage. At a minimum,
make positive contact with the bare metal chassis of the printer with the hand before
proceeding with the procedure.
Refer To Drawing 830117-XX.
TTR: 10 minutes.
Step Procedure
1 Unplug the power cord from the printer.
2
Remove the two Screws (130938) from the Headlift Motor Assembly. (Note:
The Headlift Motor Assembly is connected to the Headlift Motor Spacer and the
Headlift Gear; they will be loose once the Headlift Motor Assembly is removed.)
3 Disconnect the cable connection from J15 on the Print Circuit Board. See
Drawing 830145 for specifications.
4
Take the Headlift Motor Assembly from the printer. (Note: Apply a liberal
amount of grease to the teeth of the worm gear when installing the new Headlift
Motor Assembly. Be sure the dimples of the Headlift Motor Spacer are fitted to
the associated openings on the Chassis Assembly. Also be sure the end Shafts
of the Headlift Gear fit properly into the associated openings in the Chassis
Assembly, Headlift Motor Spacer, and the Headlift Motor Assembly before
tightening the two Screws.)