Filter
Top Products
R
ESTRICTED USE ONLY Fargo Electronics, Inc.
Persona C10/M10 ID Card Printer Service Manual (Rev. 4.0)
138
Replacing the Card Feed Roller (810304)
Refer To Drawing 830118-XX.
TTR: 15 minutes.
Step Procedure
1 Unplug the power cord from the printer.
2 Take off the Rear Pivot Cover.
3 Detach the Print Circuit Board from the chassis. Do not remove any wire
connectors unless indicated.
4 Stand at the front of the Chassis Assembly; remove the Retaining Ring
(140062) from the Card Feed Roller Shaft.
5 Remove the Drive Roller Bearing (760343) from the front Sideplate.
6 Stand at the rear of the Chassis Assembly; remove the Retainer Clip (130950)
from the Card Feed Roller Shaft. Refer to Drawing 830117-XX.
7
Slide the Card Feed Roller forward — away from the rear Sideplate. (Note:
The Card Feed Shaft Gear and Drive Roller Bearing are attached at the rear
Sideplate; they will be loose when the Card Feed Roller is removed. When
replacing the Card Feed Roller, hold the Card Feed Shaft Gear in place so the
notched end of the Shaft slides easily into the Card Feed Shaft Gear.)