FARGO electronic M10 Printer User Manual


 
R
ESTRICTED USE ONLY Fargo Electronics, Inc.
Persona C10/M10 ID Card Printer Service Manual (Rev. 4.0)
39
Resolving problems with the flashing On/Cancel LED light
Step Procedure
1
If the On/Cancel LED is flashing, this indicates a possible error with the Printer’s
memory. Contact the authorized reseller for technical assistance.
Resolving problems with Windows 95/98 printing capabilities
Print with either the 32-Bit Print Spooler or the Write Direct to Port option selected from
within the Printer Driver setup. In most cases, one or the other of these options will provide
the best results when printing from Windows 95/98.
Due to the wide variety of PC hardware and software configurations, however, some systems
may print more effectively through the Windows 95/98 print spooler.
If you choose not to print with either the 32-Bit Print Spooler or the Write Direct to Port option
selected, but instead wish to print through the Windows print spooler, the following steps will
help you optimize the system for printing:
Step Procedure
1
Click the Start button, point to Settings and select Printers. When the Printers
window appears, click on the Printer’s icon using the right mouse button and
select the Properties option.
2
Select the Details tab, then select the Spool Settings button.
3
Select the Print directly to the Printer option and click on OK.
4
Again from the Details tab, select the Port Settings button.
5
Deselect both the Check Port state before printing option and the Spool
MS-DOS print jobs option and click on OK.
6
Increase the Transmission retry value of the Details tab from 45 to 900. Click
on OK to close the Properties window.