Filter
Top Products
R
ESTRICTED USE ONLY Fargo Electronics, Inc.
Persona C10/M10 ID Card Printer Service Manual (Rev. 4.0)
136
Replacing the Card Input Roller (810262)
Refer To Drawing 830118-XX.
TTR: 15 minutes each roller.
Note: The following instructions are for the Card Input Roller near the center of the printer.
Use appropriate instructions for removing the Left Card Input Roller.
Step Procedure
1 Unplug the power cord from the printer.
2 Take off the Rear Pivot Cover.
3 Detach the Print Circuit Board from the chassis. Do not remove any wire connectors
unless indicated.
4 Stand at the front of the Chassis Assembly; remove the item; remove the Retaining
Ring (140048) from the Card Input Roller Shaft.
5 Take the Transport Roller Gear (810266) out of the printer. Be sure to note that the
wide part of the gear hub faces the Sideplate. Remember this when reinstalling it.
6 Remove the Washer Spring (130951). Be sure to note that the wave of the spring
faces the Transport Roller Gear. Remember this when reinstalling it.
7 Stand at the rear of the Chassis Assembly; remove the Retaining Ring (140048)
from the Platen Roller Shaft; this is necessary for the removal of the Idler Gear.
8 Take the Right Roller Gear from the printer. Be sure to note that the flat area on the
gear hub faces away from the Sideplate. Remember this when reinstalling it.
9 Remove the Retaining Ring (140063) from the Idler Pivot Post Shaft.
10 Take out the Idler Gear (760401). Be sure to note that the gear teeth of the center
hub face away from the Chassis Assembly. Remember this when reinstalling it.
11 Remove the Retaining Ring (140062) from the Card Input Roller Shaft.
12 Take the two Drive Roller Bearings (7603433) from the Card Input Roller.
13 Guide the Shaft forward and out of the rear Sideplate.
14 Angle the Card Input Roller up.
15 Slide the Shaft out of the front Sideplate.
16 Take the Card Input Roller from the printer