Filter
Top Products
R
ESTRICTED USE ONLY Fargo Electronics, Inc.
Persona C10/M10 ID Card Printer Service Manual (Rev. 4.0)
125
Replacing the Front Panel Board Assembly (830164)
Caution: This device is electrostatic sensitive. It may be damaged if exposed to
static electrical discharges. (Discharges may be generated by various means, such as
walking on a carpeted floor.) Be sure to observe all established Electro-Static Discharge
(ESD) procedures while handling cables in or near the Circuit Board and Printhead
Assemblies. Always wear an appropriate personal grounding device, such as a wrist strap
with integral resistor, connected to an ESD ground to avoid potential damage. At a minimum,
make positive contact with the bare metal chassis of the printer with the hand before
proceeding with the procedure.
Refer To Drawing SK1741.
TTR: 15 minutes.
Step Procedure
1 Unplug the power cord from the printer.
2 Take the Front Cover Assembly.
3 Remove the Screw that secures the Front Panel Board Assembly (830164) to
the Front Cover (SK1741).
4 Lay the Front Cover face down.
5 Lift and remove the Front Panel Board Assembly from the Front Cover.
6 Remove the two control buttons (771617) are loose; remove and set them aside.
7 Remove the item Panel Mount Bracket (830384) from the Front Panel Board.
8 Remove the Rear Pivot Cover.
9 Detach the Print Circuit Board.
10 Disconnect the cable from J2 on the Print Circuit Board.
11 Attach a piece of string to the end of the cable; use it as a means to feed the
new cable through the chassis. (See Drawing 830164 for specifications.)
12 Take the Front Panel Board Assembly from the printer.