Filter
Top Products
R
ESTRICTED USE ONLY Fargo Electronics, Inc.
Persona C10/M10 ID Card Printer Service Manual (Rev. 4.0)
119
Replacing the Power Circuit Board (140302)
Refer To Drawing 830179.
TTR: 20 minutes.
Step Procedure
1 Unplug the power cord and any external cables from the printer.
2 Refer to drawing 8301XX to remove the Screw (130971), Screw
(130939),Washer (130949), and Cable Clamp (140013) from the Power Circuit
Board Power (drawing 830179).
3 Lift up on the Backplate; guide the Power Circuit Board over the lip of the
printer baseplate.
4 Place a small piece of tape on each cable; write the cable connection location
on that tape.
5 Remove all of the cables from the Circuit Boards.
6 Remove the two Screws (130971) that secure the Print Circuit Board to the two
Standoff Screws (140047).
7 Use the thumb and index fingers of both hands to carefully pry the Print Circuit
Board from the Power Circuit Board.
8 Take the two Screws (130971) screws from the heatsink and the two corner
Screws (130971).
9
Remove the Power Circuit Board from the backplate. (Note: Apply a thin layer
of heatsink compound to the back of the heatsink for optimal heat transfer into
the backplate when replacing the Power Circuit Board. Attach the cables. Be
sure to calibrate the printer so it functions properly.)