Filter
Top Products
R
ESTRICTED USE ONLY Fargo Electronics, Inc.
Persona C10/M10 ID Card Printer Service Manual (Rev. 4.0)
128
Replacing the Card Feed Assembly (830145)
Caution: This device is electrostatic sensitive. It may be damaged if exposed to
static electrical discharges. (Discharges may be generated by various means, such as
walking on a carpeted floor.) Be sure to observe all established Electro-Static Discharge
(ESD) procedures while handling cables in or near the Circuit Board and Printhead
Assemblies. Always wear an appropriate personal grounding device, such as a wrist strap
with integral resistor, connected to an ESD ground to avoid potential damage. At a minimum,
make positive contact with the bare metal chassis of the printer with the hand before
proceeding with the procedure.
Refer To Drawing 830117-XX.
TTR: 10 minutes.
Step Procedure
1 Unplug the power cord from the printer.
2 Remove the three Screws (130938) from the Card Feed Assembly.
3 Slide the Retainer Clip from the Card Feed Roller Shaft.
4 Disconnect the cable connector from J16 on the Print Circuit Board. See
Drawing 830145 for specifications.
5
Take the Card Feed Assembly from the printer. (Note: Take care to keep the
Card Feed Roller Shaft from binding with the casing of the Card Feed Assembly
before tightening the three Screws.)