Filter
Top Products
104 SPARC Enterprise T5120 and T5220 Servers Service Manual • July 2009
FIGURE: Removing the PCIe/XAUI Riser (SPARC Enterprise T5220 Server)
8. Loosen the captive screw securing the riser to the motherboard.
9. Lift the riser up to remove it from the system.
Remove the riser and any PCIe/XAUI cards attached to it as a unit.
Related Information
■ “Install a PCIe/XAUI Riser” on page 104
■ “Remove a PCIe or XAUI Card” on page 106
■ “Install a PCIe or XAUI Card” on page 107
▼ Install a PCIe/XAUI Riser
1. Lower the PCIe/XAUI riser and any cards attached to it into the system.
Note – PCIe/XAUI and PCIe risers have keyed connectors to prevent incorrect
installation on the motherboard.
2. Ensure that the PCIe back panels are properly engaged with the corresponding
slots in the motherboard tray/back panel connector assembly.
3. Tighten the captive screw to secure the riser to the motherboard.
Note – Ensure that PCIe filler panels are installed in all empty PCIe/XAUI slots.