Filter
Top Products
1-5
Different applications treat these changes in different ways.
GCC recommends that you make changes in the application’s Page Setup or Print dialog
boxes. If you find that you are making the same changes for every print job, use the Printer
Setup dialog boxes or the Elite 12ppm control panel menus to make these settings the
default.
You’ll find instructions on changing the settings through the control panel menus (or
GCC’s WebAdmin tool) elsewhere in the manual. The instructions for changing the set-
tings in the Printer Setup dialog boxes are in the sections on each type of computer or
operating system.
Page Setup and Print dialog boxes vary from application to application. You’ll find details
in your application’s manuals.
Setting up the Elite 12ppm
Choosing a location for the printer
Place the printer on a flat level surface in a well ventilated area away from direct sunlight
and areas where the air temperature and humidity can vary. Do not obstruct the fan vent
on the right side of the printer, and make sure that the fan vent does not blow air directly
onto someone’s face.
Use the diagram below to determine where to put your printer.
8 inches (200mm)
minimum overhead
clearance.
7.2 inches
(180mm)
1 inch
(25mm)
12.4 inches
(310mm)
without Duplex
10.8 inches
(270mm)
21.8 inches
(545mm)
with Duplex