Filter
Top Products
2-11
Submenu
8-pin serial
RS422 Serial
(5 submenus)
RS422 Baud Rate: The RS422 baud rate.
RS422 Data Bits: The number of data bits
sent with each serial byte.
RS422 Stop Bits: The number of stop bits
sent with each serial byte.
RS422 Parity: The parity sent with each
serial byte.
RS422 Flow Control: Which flow control
is used by the RS422 serial port.
Settings
LocalTalk or RS422
300, 600, 1800, 2400, 3600, 4800,
7200, 9600, 19200, 38400, or
57600.
8 or 7
1, 1.5, or 2
None, Even, or Odd
XON/XOFF, XON/XOFF Input,
or DTR
Notes
If you change the 8-pin serial setting, you must
restart the printer.
The RS422 menu only appears when you choose
the RS422 option in the 8-pin serial menu.
Always set this to DTR when you send a PCL
job.
7. Interfaces – press the Enter key to access the submenus. The Interfaces submenus also
have submenus.
TCP/IP: Whether print jobs will be accepted
over a TCP/IP network.
There are twelve other submenus in the TCP/IP
menu system; you will need to configure these
to run TCP/IP. Full details of the menus and
their recommended settings are in the TCP/IP
section of the networking guide on this CD-
ROM.
NEST (1200 dpi model only): Allows you
to configure the printer on a Novell network
without needing to use a computer as a print
server.
Frame Type: The Frame Type of printers on
the Novell network.
Enabled or Disabled.
Enabled or Disabled.
802.2, 802.3, Ethernet II, or
SNAP.
TCP/IP will not be operational until you have
configured the settings in the TCP/IP submenus.
Until then, setting this switch to Enabled has no
effect. When TCP/IP is configured, this menu will
allow you to turn it on and off. For full details, see
the TCP/IP section of the networking guide on
this CD-ROM.
If the Frame Type differs from what you specified
in the NEST software, the printer will not be
available to the network.