Filter
Top Products
1-6
Removing the printer from the shipping box
Warning: The printer weighs about 30 pounds (about 14 kilograms).
Note: Save the packing materials inside the shipping box and put the box in a safe place;
you will be able to repack the printer should you need to move it again.
1. Take the printer out of the of the box and remove the packing material.
2. Take the printer out of the plastic bag.
3. Take the documentation and CD-ROM out of the plastic bag.
4. Check that you have all of the following:
G
CC
T
ECHNOLOGIES
Elite
™
12ppm
Configuration Page
Printer Information
Interfaces
Paper Handling
Language: English
AppleTalk Name: Model
Page Count: 20
RAM Installed: 8MB
Hard disk: No disk
OS Version: 2.3
PostScript Level 2 Version: 2.3
ROM Version: 2.3
H/W Version: 1.0
AccuGray: Enabled
Print Darkness: Normal
Default Source: Upper Tray
Default Size: Letter
Jam Recovery: Disabled
Paper Reserve: Enabled
Manual Feed Timeoutt: 5 Minutes
8-pin Serial: LocalTalk
RS422 Serial (Inactive)
Baude Rate: 9600
Data Bits: 8
Stop Bits: 1
Parity: None
Flow Control: Xon/Xoff
RS232 Serial (Active)
Baude Rate: 9600
Data Bits: 8
Stop Bits: 1
Parity: None
Flow Control: Xon/Xoff
Parallel Port (Active)
PS/PCL Sensing: PostScript Only
Port Emulation
Parallel Port: Auto Switch
RS232 Port: Auto Switch
RS422 Port: Auto Switch
LocalTalk Port: PostScript Only
PostScript
Default Resolution: 800
Job Cancel: Enabled
Start Page: Disabled
Wait Timeout: 300 Seconds
PCL
Resolution: 600
Copies: 1
Font Source: Internal
Font Number: 1
Pitch: 10.0
Point Size: 12.0
Orientation: Portrait
Page Length: 60
Symbol Set: Roman-8
Wait Timeout: 120 Seconds
Line Wrap: Disabled
Line Termination: Normal
Emulations
Configuration page
Toner cartridge
(in box)
Installation guide Elite 12ppm CD-ROM Universal paper tray
AC power cord
Elite
12ppm
INSTALLATION GUIDE
If any of these items are missing, contact your dealer or GCC Technical Support (781-276-
8620) immediately.
You will need to provide a cable to connect your computer or network to the printer.
Warning: If you use the parallel port interface, the cable you use must be suitable for
bi-directional transmission (IEEE 1284). Standard (unidirectional) parallel cables can
cause errors in printing.
Removing additional packing
1. Remove the tape from the printer’s top cover.