Filter
Top Products
does not allow a physical connection to the "2-EXT" port on your HP All-in-One.
Instead, all equipment must be connected at the telephone wall jack.
● If your country/region is listed in the table below, you probably have a parallel-
type telephone system. In a parallel-type phone system, you are able to connect
shared telephone equipment to the phone line by using the "2-EXT" port on the
back of the HP All-in-One.
Note If you have a parallel-type phone system, HP recommends you use
the 2-wire phone cord supplied with your HP All-in-One to connect the
HP All-in-One to the telephone wall jack.
Countries/regions with a parallel-type phone system
Argentina
Australia Brazil
Canada Chile China
Colombia Greece India
Indonesia Ireland Japan
Korea Latin America Malaysia
Mexico Philippines Poland
Portugal Russia Saudi Arabia
Singapore Spain Taiwan
Thailand USA Venezuela
Vietnam
If you are unsure which kind of telephone system you have (serial or parallel), check
with your telephone company.
Choose the right fax setup for your home or office
To fax successfully, you need to know what types of equipment and services (if any)
share the same phone line with your HP All-in-One. This is important because you
might need to connect some of your existing office equipment directly to your HP All-
in-One, and you might also need to change some fax settings before you can fax
successfully.
To determine the best way to set up the HP All-in-One in your home or office, first
read through the questions in this section and record your answers. Next, refer to the
table in the following section and choose the recommended setup case based on your
answers.
Make sure to read and answer the following questions in the order they are presented.
1. Do you have a digital subscriber line (DSL) service through your telephone
company? (DSL might be called ADSL in your country/region.)
❑
Yes, I have DSL.
❑
No.
User Guide 35
Finish setup