Filter
Top Products
Back view of the HP All-in-One
1 Telephone wall jack
2 Phone cord supplied in the box with your HP All-in-One connected to the "1-LINE" port
To set up your HP All-in-One with a distinctive ring service
1. Using the phone cord supplied in the box with your HP All-in-One, connect one
end to your telephone wall jack, then connect the other end to the port labeled "1-
LINE" on the back of your HP All-in-One.
Note If you do not use the supplied cord to connect from the telephone
wall jack to your HP All-in-One, you might not be able to fax successfully.
This special phone cord is different from the phone cords you might
already have in your home or office. If the supplied phone cord is too
short, see The phone cord that came with my HP All-in-One is not long
enough for information on extending it.
2. Set the Auto Answer setting to On.
For information on changing this setting, see Set the answer mode.
3. Change the Answer Ring Pattern setting to match the pattern that the telephone
company assigned to your fax number.
For information on changing this setting, see Change the answer ring pattern
(distinctive ringing).
Note By default, your HP All-in-One is set to answer all ring patterns. If
you do not set the Answer Ring Pattern to match the ring pattern
assigned to your fax number, your HP All-in-One might answer both voice
calls and fax calls or it might not answer at all.
4. (Optional) Change the Rings to Answer setting to the lowest setting (two rings).
For information on changing this setting, see Set the number of rings before
answering.
5. Run a fax test. For information, see Test your fax setup.
Your HP All-in-One will automatically answer incoming calls that have the ring pattern
you selected (Answer Ring Pattern setting) after the number of rings you selected
(Rings to Answer setting). Then it will begin emitting fax reception tones to the
sending fax machine and receive the fax.
Chapter 3
42 HP Photosmart 3300 All-in-One series
Finish setup