Filter
Top Products
To install the Mac HP All-in-One software
Note The following instructions are for Mac computers only.
1. Quit all applications running on your computer.
2. Insert the Mac CD that came with your HP All-in-One into the CD-ROM drive on
your computer.
3. Double-click the HP All-in-One installer icon.
4. On the Authentication screen, enter the Administrator password used to access
your computer or network.
The installer software looks for HP All-in-One devices, and then lists them.
5. On the Select Device screen, select your HP All-in-One.
6. Follow the onscreen instructions to complete all the installation steps, including
the Setup Assistant.
When you have finished installing the software, your HP All-in-One is ready for
service.
7. To test your network connection, go to your computer and print a self-test report
to your HP All-in-One. For more information, see Print a self-test report.
Connect to additional computers on a network
You can connect your HP All-in-One to more than one computer on a small network of
computers. If your HP All-in-One is already connected to a computer on a network, for
each additional computer you must install the HP All-in-One software, as described in
Install the software for a network connection. During installation of a wireless
connection, the software will discover the SSID (network name) of the existing
network. Once you have set up your HP All-in-One on the network you will not need to
configure it again when you add additional computers.
Note You can have both a wired or wireless connection and a USB
connection to your HP All-in-One. However, you cannot have both a wired and
a wireless connection to the same HP All-in-One.
Change the HP All-in-One from a USB connection to a
network connection
If you first install your HP All-in-One with a USB connection, you can later change to
either a wireless or Ethernet network connection. If you already understand how to
connect to a network, you can use the general directions below. For more detailed
instructions on connecting a HP All-in-One to a network, see Wireless infrastructure
network setup, Wireless ad hoc network setup, or Wired network setup.
Note For optimal performance and security in your wireless network, use an
access point (such as a wireless router) to connect your HP All-in-One.
To change a USB connection to a wireless connection
1. Unplug the USB connection from the back of your HP All-in-One.
2. Press Setup on the control panel of your HP All-in-One.
Chapter 4
72 HP Photosmart 3300 All-in-One series
Network setup