Filter
Top Products
Change advanced network settings from the control panel settings
The advanced network settings are provided for your convenience. However, unless
you are an advanced user, you should not change any of these settings. The
advanced settings include Link Speed, IP Settings, and Memory Card Security.
Set link speed
You can change the speed at which data is transmitted over the network. The default
is Automatic.
1. Press Setup.
2. Press
until Network is highlighted, then press OK.
The Network Menu appears.
3. Press 3, then press 1.
This selects Advanced Setup and then displays the Link Speed screen.
4. Press the number next to the link speed that matches your network hardware:
– 1. Automatic
– 2. 10-Full
– 3. 10-Half
– 4. 100-Full
– 5. 100-Half
Change IP settings
The default IP setting for the IP settings is Automatic, which sets the IP settings
automatically. However, if you are an advanced user, you might want to manually
change the IP address, subnet mask, or the default gateway. To see the IP address
and subnet mask of your HP All-in-One, print a network configuration page from your
HP All-in-One. For more information on printing a configuration page, see View and
print network settings. For a description of the items on the configuration page,
including the IP address and subnet mask, see Network configuration page definitions.
Caution Be careful when manually assigning an IP address. If you enter an
invalid IP address during the installation, your network components will not be
able to connect with the HP All-in-One.
1. Press Setup.
2. Press
until Network is highlighted, then press OK.
The Network Menu appears.
3. Press 3, press 2, and then press 2 again.
This selects Advanced Setup, then IP Settings, and then displays the Manual
IP Settings screen.
4. Press the number next to the IP setting:
– 1. IP Address
– 2. Subnet Mask
– 3. Default Gateway
5. Enter your changes, then press OK when done.
User Guide 75
Network setup